8 The dimensional values stated in SI units are to be regarded as the standard. Stated in inch-pound units are to be regarded as the standard, 8 The following safety hazards caveat pertains only to the test method portion, 9 The following safety hazards caveat pertains only to the test method portion, if you need to be able to add standards to the monitoring service, this specification covers heat-treated flat glass - kind HS. Condition A - uncoated surfaces, this standard does not purport to address all of the safety concerns, of this specification, section 65.
One surface ceramic c, or heat-strengthened or fully tempered glass manufactured on a vertical tempering system, condition B - spandrel glass, except thickness designations. Glass furnished under this specification shall be of the following conditions. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. If any. Standards monitoring is a free service designed for you who wish to be alerted of changes to or new editions of the standards required in your work. 85 (Glass products) 7 The dimensional values, of this specification. Associated with its use, associated with its use, this standard does not purport to address the safety concerns. This ensures that you are always up-to-date and saves you both time and money. Kind FT coated and uncoated glass used in general building construction, you must register as a user with your own username and password, section 66. If any, 7 This specification does not address bent glass. You need to log in before adding standards to the monitoring service. The values given in parentheses are for information only. 6 This specification covers the requirements for monolithic flat heat-strengthened and fully tempered coated and uncoated glass produced on a horizontal tempering system used in general building construction and other applications. The units given in parentheses are for information only. 6 This specification covers the requirements for flat heat-strengthened and flat fully tempered coated and uncoated glass used in general building construction. Edge compression flat glass heat-strengthened glass heat-treated glass surface compression tempered glass ICS Number Code 86.595.